Yamaha RX-V2700 User Manual

■

Use this feature to manually balance the speaker levels 
between the front left or surround left speakers and each 
speaker selected in “SPEAKER SET” (see page 96).

Control range: –10.0 dB to +10.0 dB
Initial setting: 
Front L/Front R/Presence L/Presence R/
Subwoofer: 0.0 dB
Center/Surround L/Surround R/Surround Back L/
Surround Back R: –1.0 dB
Control step: 0.5 dB
• Select “Front L” to adjust the balance of the front left 

speaker.

• Select “Front R” to adjust the balance of the front right 

speaker.

• Select “Center” to adjust the balance of the center 

speaker.

• Select “Surround L” to adjust the balance of the 

surround left speaker.

• Select “Surround R” to adjust the balance of the 

surround right speaker.

• Select “Surround Back L” to adjust the balance of the 

surround back left speaker.

• Select “Surround Back R” to adjust the balance of the 

surround back right speaker.

• Select “Presence L” to adjust the balance of the 

presence left speaker.

• Select “Presence R” to adjust the balance of the 

presence right speaker.

• Select “Subwoofer” to adjust the balance of the 

subwoofer.

• You cannot adjust the level of channels set to “None” in 

Speaker Set.

• If you are only using one surround back speaker, connect it to 

the SURROUND BACK (SINGLE) jack, and adjust the balance 
in “Surround Back L”.

Use this menu to adjust the network and USB system 
parameters.

■

Use this feature to view the network parameters (IP 
address, etc.) or to change them manually.

The above display is an example.

When this parameter is set to “ON”, network parameters 
for “IP Address”, “Subnet Mask”, “Default Gateway”, 
“DNS Server (P)” and “DNS Server (S)” obtained from a 
DHCP enabled router are displayed. If DHCP server 
function is not available, set this parameter to “Off” to 
configure the network parameters manually.
Choices: 

, Off

Use this parameter to specify an IP address assigned to 
this unit. This value must not duplicate the one used for 
other devices in the target network.

Use this parameter to specify the subnet mask value 
assigned to this unit.

y

For most of the cases, the subnet mask value can be set as 
“255.255.255.0”.

Use this parameter to specify the IP address of the default 
gateway.