SVAT Electronics CLEARVU11 User Manual

now you can see

CLEARVU11

29

The following is a brief description of each item and its specific operations:

•  Size (GB) – the total HDD storage in GB (Giga-Byte) for Alarm Record and Normal Record respectively. This item 

is just for information. Please refer to the section on HDD format/clear for detailed information and setup.

•  Auto Overwrite – allows you to automatically overwrite the recorded video/audio from HDD#1 when the 

Alarm/Normal Record disk drive capacity is full. If Auto Overwrite is disabled and the Alarm/Normal Record disk 

drive capacity reaches the end, the system will not overwrite the recorded video/audio, and hence not record 

Alarm/Normal video/audio, until the user presses the Alarm Reset button. Press ENTER or +/- to check/

uncheck this item. The default setting is “” - checked.

•  HDD Full Action –Activates certain actions when Alarm/Normal Record disk drive capacity reaches the end of 

the last HDD. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

•  Duration – response duration to define how long (in seconds) the Alarm Out relay and the Buzzer will keep 

being triggered after the corresponding selection, Alarm Record or Normal Record, is full. Press +/- buttons to 

adjust the value (3-60 seconds, discrete).

•  Alarm Out – to define which Alarm Output will be triggered when the corresponding selection, Alarm Record 

or Normal Record, is full. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).

•  Buzzer – to activate the internal Buzzer or not when the corresponding partition, Alarm Record or Normal 

Record, is full. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

•  Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this item. The default setting is “” - 

checked.

•  E-mail – to send the event e-mail to a pre-determined email address or not. The e-mail will be sent to the 

predefined receivers when the event is triggered. Press ENTER or +/- to check/uncheck this item. The default 

setting is “–” - unchecked.

The general operations are as below:

•

▲▼◄►- Press these buttons to select the items.

•  MODE - Format/Clear - Press this button to format/clear the HDDs as described in the next section.
•  ESC (MENU/ESC) - Press this button to escape from this screen, and return to Setup Menu display. If the Save 

dialog is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.