Panasonic NV-DS30A User Manual

Page of 60
14
Using the Menu Screen
To facilitate the selection of a desired function or setup, this Movie 
Camera displays various function setups on Menus.
1
Press the [MENU] Button.
≥The Menu corresponding to the Mode selected by using the 
[VCR/OFF/CAMERA/M-CARD] Switch 
1
 is displayed.
2
Turn the [PUSH] Dial to select a desired Sub-Menu.
≥Turn the [PUSH] Dial to display the highlightened item.
3
Press the [PUSH] Dial to display the selected Sub-
Menu.
4
Turn the [PUSH] Dial to select the item to be set.
5
Press the [PUSH] Dial to set the selected item to a 
desired mode.
≥With each pressing of the [PUSH] Dial, the cursor [1] moves 
to the next mode.
≥While a Menu is displayed, you cannot record or play back. Menus 
can be displayed during playback but not during recording. The 
above operations can be done using the [MENU] Button, [SET] 
Button and [ITEM] Button on the Remote Controller. (
To Exit the Menu Screen
Press the [MENU] Button again.
About the Menu Mode Setting
The setting selected on the Menu will be retained even when the 
Movie Camera is turned off. However, if the Battery or AC Adaptor is 
disconnected before turning off the Movie Camera, the selected 
setup may not be retained.
≥Menu operation flow is shown in this text by >>.
ª Image Selection (NV-DS50 only)
An Image Selection Operation may be necessary during Menu 
Operations. In this case, carry out the following procedure.
1
1
1
1
Turn the [PUSH] Dial and select a picture.
≥The selected picture is underlined 
2
.
2
2
2
2
Press the [PUSH] Dial to confirm the selection of the 
picture.
≥After the above Picture Selection Procedure, carry out the various 
Menu Operations. (The above procedure will not be repeated in 
the following instructions.)
2
PUSH
W.B./SHUTTER
IRIS/MF/JOG
1
2
DELETE:M-DEL  D-000
PRESS STOP TO EXIT
1
2
3
4
5
6
MENU
PUSH
W.B./SHUTTER
IRIS/MF/JOG
1
2, 3, 4, 5
1
A-ENG.book  14 ページ  2002年1月28日 月曜日 午前11時32分