Radio Shack 15-133 User Manual

Your remote comes pre-programmed to 
operate SONY TVs, DVD players, VCRs, Audio 
Receivers and DIRECTV HD or HD with PVR 
satellite receiver. To control other brands, 
follow these steps to program your remote.
Before proceeding, find the codes for your 
devices in “Manufacturers Codes.”

1. Turn on the device (for example, DVD 

player) and, if needed, load media (for 
example, a DVD).

2. On the remote, press a device key (TV, 

CBL/SAT, DVD, VCR or AUD).

3. Press and hold P until the LED blinks 

twice, then release.

4. Enter the first five-digit code for your 

device. The LED blinks once as you enter 
each digit. If the code is correct, the LED 
blinks twice. 

5. Aim the remote at the device and press 

Power (or PLAY, if the device does not 
have a Power key). The device should 
turn off. If it does not, repeat steps 2-5, 
trying each code for your brand until you 
find one that works. If you cannot find 
a code that works, perform the steps in 
“Searching for Your Code.”

6. Repeat steps 1 to 5 for each device you 

want to program.

If no key is pressed within 10 seconds, the 
remote control exits the programming.
To program a TV/DVD, TV/VCR/DVD, or TV/ 
VCR Combo, use the TV, DVD, or VCR device 
key. 
If you have a VCR/DVD combo, you may need 
to set up both a VCR and DVD code.