Braun 32899 Rev A User Manual

Page 17

In the event the Rampvan is in the 
kneeled position and you experi-
ence power or equipment failure, 
an electrical override and a me-
chanical override are available to 
raise the rear of the vehicle.  The 
vehicle cannot be lowered using 
override features.

Use the Electrical Override Switch 
if possible (details at right).  The 
rear of the vehicle can be raised 
using the mechanical override 
if there is an electrical problem 
(manual procedures).  See Kneel
Mechanical Override on next page.    

Do not drive the Rampvan with the 
rear of the vehicle in the lowered 
position.  Attempting to do so will 
result in an extremely rough and 
unstable ride.

In the event of a kneel system 
failure, have the kneel system 
repaired immediately.  Contact 
your sales representative or 
call The Braun Corporation at 
1-800-THE LIFT

®

.  One of our 

national Product Support rep-
resentatives will direct you to 
an authorized service center.

The Kneel Override is avail-
able to electrically power the 
kneel system direct (by-pass-
ing the electronic control 
system).  The Kneel Override 
Switch is located on the pas-
senger side C-pillar (rear of 
the slide door).

Press and hold the switch to re-
lease the kneel system (raise ve-
hicle).  Release the switch when 
the rear of the Rampvan has 
raised fully.  The kneel actuator 
motor will ratchet (make clicking 
sound).

3UHVVDQGKROG this switch to 
release kneel (raise vehicle).

Kneel Override Switch