Braun 32899 Rev A User Manual

Page 19

The power ramp is activated by 
the One-Touch electronic control 
system.  When a control switch is 
pressed to start the Open func-
tions, the power door opens.  Once 
the door reaches the fully open po-
sition, there is a slight delay before 
the ramp begins to deploy.  

When the Close functions are 
activated, the ramp (stows) im-
mediately.

If a control switch is pressed and 
released while the ramp is de-
ploying, the ramp motor will stop 
running.  Press a switch again and 
the ramp will stow and the door will 
close.

Once the Open sequence of func-
tions is complete (door is fully open 

and ramp is deployed), press and 
release a control switch to stow the 
ramp.  If a control switch is pressed 
while the ramp is stowing, the ramp 
will reverse direction (deploy fully 
and stop).  Press a control switch 
again and the ramp will stow and 
the door will close.

Note:  If the center console Kneel 
On/Off switch is in the ON position, 
the rear of the vehicle will descend 
as the ramp is deploying.  Inversely, 
the vehicle will raise when the ramp 
is stowing.

Manual operation of the passen-
ger slide door handles will disable 
ramp deployment.  To enable ramp 
deployment, close the passenger 
slide door using the keyless entry 
transmitter, any interior mounted 
switch or the magnetic entry (if 
equipped).

If the power ramp is obstructed 
while deploying, the ramp will 
reverse direction and stow fully 
SURYLGHGWKHUDPSPHHWVVXIÀ-
cient resistance).

Allow the power ramp to deploy 
(unfold and lower) fully before 
boarding the ramp.  Forcing the 
ramp out or down during the 
deploy/stow functions, or board-
ing onto the ramp before it is fully 
deployed

to the ramp, the electronic control-
ler and/or motor assembly.