Adtran 616 User Manual

Section 4  User Interface Guide

Total Access 600 Series System Manual

 174

© 2004 ADTRAN, Inc.

61200624L1-1B

The Total Access 6XX allows for complete integration of voice and data delivery from one compact 
platform (see Figure 10). Once you have completed the voice turn up procedure from the previous 
example, adding data to the circuit requires some additional setup.

To configure a Total Access 6XX for IP routing, you need to know the VPI and VCI values for the data 
circuit on your network. You also need the IP address of the next hop router in the circuit. 

Perform the following steps in order to configure the application.

It is best to configure Total Access 6XX ATM applications by following the order of the top-level menus. 
For example, first configure the system parameters using the 

 and 

 menus. 

Next, configure the Layer 1 parameters using the 

 menu. Once the Layer 1 information is 

configured, proceed to the Layer 2 setup using the 

 menus. Follow the Layer 2 setup with the 

data “routing” menus (either 

 or 

). Finally, establish packet forwarding and blocking using 

the 

 menus. 

The following example provides step by step instructions for configuring the Total Access 6XX T1 ATM 
system (

 and 

) for a standard routing application. System Info and System Config 

parameters should be set according to your system need. Refer to System Info on page 49 and System 
Config on page 51 for more details.

For more details on the configuration parameters discussed in this section, refer to the following pages: