Adtran 616 User Manual

Section 4  User Interface Guide

Total Access 600 Series System Manual

 76

© 2004 ADTRAN, Inc.

61200624L1-1B

Internal ADTRAN use only.

Internal ADTRAN use only.

Displays the current G.shdsl signaling method as either 

 or 

.

Displays statistics for information transferred between the Total Access 6XX and the DSLAM over the 
EOC.

Displays the current layer one SHDSL information including signal to noise ratio (SNR), errored seconds 
(ES), severely errored seconds (SES), unavailable seconds (UAS), and code violations.

View the network SDSL interface status and configure SDSL parameters from this menu. These menus are 
only applicable to SDSL Total Access 600 Series systems.

Configure the various SDSL parameters from this menu (such as DSLAM type).

Specify the type of DSLAM the Total Access 6XX SDSL unit is connected to. Choices include: 

, 

, and 

. DSLAM setup parameters will vary depending on 

configured DSLAM type.

Configure the DSLAM settings from this menu.

Specifies the training method for the SDSL link as either 

 (using only the specified rate) or 

 (which allows for the fastest negotiated rate).

Configures the fixed data rate used when training the SDSL link. This menu only applies when the 
Training parameter is specified for 

. Using a fixed data rate requires the DSLAM to be 

configured for the same rate as the Total Access 6XX. Choices vary depending on configured DSLAM and 
range from 

to

.