Sharp PG-M25X Operating Guide
Image Projection
Basic Procedure
Connect the required external equipment to the
projector before operating the following procedures.
Details are found in the projector operation
manual.
projector before operating the following procedures.
Details are found in the projector operation
manual.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 37.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 37.
1
Plug the power cord into the wall outlet.
•
The POWER indicator illuminates up in red,
and the projector enters standby mode.
and the projector enters standby mode.
2
Press
on the projector or
on the GyroRemote.
•
The POWER indicator illuminates in
green. After the LAMP REPLACEMENT
indicator illuminates, the projector is
ready to start operation.
green. After the LAMP REPLACEMENT
indicator illuminates, the projector is
ready to start operation.
Note
•
The LAMP REPLACEMENT indica-
tor illuminates, indicating the status
of the lamp.
tor illuminates, indicating the status
of the lamp.
Green: The lamp is ready.
Green blinking: The lamp is
Green blinking: The lamp is
warming up.
Red: The lamp should be replaced.
•
If the power is turned off and
immediately switched on again, the
LAMP REPLACEMENT indicator may
take time to illuminate.
immediately switched on again, the
LAMP REPLACEMENT indicator may
take time to illuminate.
When “Anti-Theft” (see page 102) is
set, the keycode input box will appear.
set, the keycode input box will appear.
•
Enter the keycode.
Note
•
When entering the keycode, press
the buttons previously set on the
projector or the GyroRemote.
the buttons previously set on the
projector or the GyroRemote.
Info
•
When “Anti-Theft” is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (See page 102.)
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (See page 102.)
▼Projector indicators
LAMP REPLACEMENT indicator
POWER indicator
POWER button
INPUT
button
button
INPUT button
POWER button
▼Keycode input box
-34
Volume
buttons
buttons
AV MUTE
button
button
Volume button
PG-M25X#E#p33_49.p65
02.4.29, 3:11 PM
34