Bosch UML-262-90 User Manual

Full HD LCD Monitors

Safety | en

Bosch Security Systems, Inc.

User’s Manual

F.01U.172.600 | 1.0 | 2010.10

Power lines - Do not locate the display near overhead power 

lines, power circuits, or electrical lights, nor where it may 

contact such power lines, circuits, or lights.

–

Ventilation - Do not place this unit in a built-in installation 

or rack without proper ventilation or adhering to the 

manufacturer's instructions. The equipment must not 

exceed its maximum operating temperature requirements.

–

Mechanical loading - Properly mount the equipment in a 

rack to prevent a hazardous condition due to uneven 

mechanical loading.

All the input/output ports are Safety Extra Low Voltage (SELV) 

circuits. SELV circuits should only be connected to other SELV 

circuits.

Because the ISDN circuits are treated like telephone-network 

voltage, avoid connecting the SELV circuit to the Telephone 

Network Voltage (TNV) circuits.

The system ground is only used to comply with safety standards 

or installation practices in certain countries. Bosch does not 

recommend connecting system ground to safety ground unless 

it is explicitly required. However, if the system ground and 

safety ground are connected and grounding loops are causing 

interference in the video signal, use an isolation transformer 

(available separately from Bosch).

Video loss - Video loss is inherent to digital video recording; 

therefore, Bosch Security Systems cannot be held liable for any 

damage that results from missing video information. To 

minimize the risk of lost digital information, Bosch Security 

Systems recommends multiple, redundant recording systems, 

and a procedure to back up all analog and digital information.

Connecting System ground to Safety ground may result in 

ground loops that can disrupt the CCTV system.