3com V7111 User Manual
Table 9
V7111 Default Networking Parameters
Parameter Default
Value
FXS 10.1.10.10
FXO 10.1.10.11
FXS / FXO
10.1.10.10
V7111 default subnet mask is 255.255.0.0, default gateway IP address is 0.0.0.0
Assigning an IP Address Using HTTP
To assign an IP address using HTTP, follow these 8 steps:
1
Disconnect the V7111 from the network and reconnect it to your PC using one of the
following two methods:
following two methods:
Use a standard Ethernet cable to connect the network interface on your PC to a port
on a network hub / switch. Use a second standard Ethernet cable to connect the
V7111 to another port on the same network hub / switch.
V7111 to another port on the same network hub / switch.
Use an Ethernet cross-over cable (for the V7111 24-PORT) or a standard Ethernet
cable (for the V7111) to directly connect the network interface on your PC to the
V7111.
V7111.
2
Change your PC’s IP address and subnet mask to correspond with the V7111 factory
default IP address and subnet mask, shown in
default IP address and subnet mask, shown in
address and subnet mask of your PC, refer to Windows™ Online Help (Start>Help).
3
Access the V7111 Embedded Web Server (see
4
In the ‘Quick Setup’ screen, set the V7111 ‘IP Address’, ‘Subnet Mask’ and ‘Default
Gateway IP Address’ fields under ‘IP Configuration’ to correspond with your network IP
settings.
Gateway IP Address’ fields under ‘IP Configuration’ to correspond with your network IP
settings.
If your network doesn’t feature a default gateway, enter a dummy value in the
‘Default Gateway IP Address’ field.
5
Click the Reset button and click OK in the prompt; the V7111 applies the changes and
restarts. This takes approximately 2 minutes to complete. When the V7111 has finished
restarting, the Power and Ready LEDs on the front panel are lit green.
restarts. This takes approximately 2 minutes to complete. When the V7111 has finished
restarting, the Power and Ready LEDs on the front panel are lit green.
Record & retain the IP address and subnet mask you assign the V7111. Do the
same when defining new username or password. If the Embedded Web Server
is unavailable (for example, if you’ve lost your username and password), use
the BootP/TFTP configuration utility to access the device, “reflash” the load and
reset the password (refer to the V7111 User’s Manuals for detailed information
on using a BootP/TFTP server to access the device).
same when defining new username or password. If the Embedded Web Server
is unavailable (for example, if you’ve lost your username and password), use
the BootP/TFTP configuration utility to access the device, “reflash” the load and
reset the password (refer to the V7111 User’s Manuals for detailed information
on using a BootP/TFTP server to access the device).
6
Disconnect your PC from the V7111 or from the hub / switch (depending on the
connection method you used in
connection method you used in
).
7
Reconnect the V7111 and your PC (if necessary) to the network.
26
3Com VCX V7111 Analog Gateway Installation Guide