Patton electronic SmartNode 4110 Series User Manual
Link scheduler configuration task list
167
SmartWare Software Configuration Guide
13 • Link scheduler configuration
Devoting the service policy profile to an interface
Any service policy profile needs to be bound to a certain IP interface to get activated. According the terminol-
ogy of SmartWare a service policy profile is used on a certain IP interface, as shown in
ogy of SmartWare a service policy profile is used on a certain IP interface, as shown in
Figure 27. Using a Service Policy Profile on an IP Interface
Therefore the
use profile service-policy
command allows attaching a certain service policy profile to an IP
interface that is defined within the IP context. This command has an optional argument that defines whether
the service policy profile is activated in receive or transmit direction.
the service policy profile is activated in receive or transmit direction.
Providers may use input shaping to improve downlink voice jitter in the absence of voice support. The default
setting
setting
no service-policy
sets the interface to FIFO queuing.
Mode: Interface
Example: Devoting the service policy profile to an interface
The following example shows how to attach the service policy profile Voice_Prio to the IP interface wan that is
defined within the IP context for outgoing traffic.
defined within the IP context for outgoing traffic.
node>enable
node#configure
node(cfg)#context ip router
node#configure
node(cfg)#context ip router
Step
Command
Purpose
1
node(if-ip)[if-name]#use profile service-
policy name {in | out}
policy name {in | out}
Applies the service policy profile name to the
selected interface if-name. Depending on select-
ing the optional in or out argument the service
policy profile is active on the receive or transmit
direction. Be aware that service policy profiles
can only be activated on the transmit direction at
the moment.
selected interface if-name. Depending on select-
ing the optional in or out argument the service
policy profile is active on the receive or transmit
direction. Be aware that service policy profiles
can only be activated on the transmit direction at
the moment.
Context
IP
“router”
use command
Service
Policy
Profile
bind command
PVC
Serial
Ethernet