Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Link scheduler configuration task list

SmartWare Software Configuration Guide 

Any service policy profile needs to be bound to a certain IP interface to get activated. According the terminol-
ogy of SmartWare a service policy profile is used on a certain IP interface, as shown in 

Figure 27. Using a Service Policy Profile on an IP Interface

Therefore the 

 command allows attaching a certain service policy profile to an IP 

interface that is defined within the IP context. This command has an optional argument that defines whether 
the service policy profile is activated in receive or transmit direction.

Providers may use input shaping to improve downlink voice jitter in the absence of voice support. The default 
setting 

 sets the interface to FIFO queuing.

Mode: Interface

Example: Devoting the service policy profile to an interface

The following example shows how to attach the service policy profile Voice_Prio to the IP interface wan that is 
defined within the IP context for outgoing traffic.

node>enable
node#configure
node(cfg)#context ip router

Applies the service policy profile name to the 
selected interface if-name. Depending on select-
ing the optional in or out argument the service 
policy profile is active on the receive or transmit 
direction. Be aware that service policy profiles 
can only be activated on the transmit direction at 
the moment.

Context

IP

“router”

use command

Service

Policy

Profile

bind command

PVC

Serial

Ethernet