ZyXEL Communications EMG5324-D10A User Manual
Chapter 1 Introduction
EMG5324-D10A User’s Guide
22
1.7 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the passwords will be reset to the defaults.
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the passwords will be reset to the defaults.
1
Make sure the POWER LED is on (not blinking).
2
To set the device back to the factory default settings, press the RESET button for 5 seconds or until
the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the
defaults have been restored and the device restarts.
the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the
defaults have been restored and the device restarts.