ZyXEL Communications FMG3024-D10A User Manual

 Chapter 5 Broadband

FMG3024-D10A / FMG3025-D10A Series User’s Guide

Broadband Add/Edit: Bridge 

The following table describes the fields in this screen.

Use this screen to configure your 3G settings. Click Broadband > 3G Backup.

At the time of writing, the 3G card you can use in the Device is Huawei E220, E270, E160, E169G.

Note: The actual data rate you obtain varies depending the 3G card you use, the signal 

strength to the service provider’s base station, and so on.

If the signal strength of a 3G network is too low, the 3G card may switch to an available 2.5G or 
2.75G network. Refer to 

 for a comparison between 2G, 2.5G, 2.75G and 3G 

wireless technologies.

Broadband Add/Edit: Bridge 

General

Name

Enter a service name of the connection.

Mode

Select Bridge when your ISP provides you more than one IP address and you 
want the connected computers to get individual IP address from ISP’s DHCP 
server directly. If you select Bridge, you cannot use routing functions, such as 
QoS, Firewall, DHCP server and NAT on traffic from the selected LAN port(s).

Enable VLAN

Select this to add the VLAN Tag (specified below) to the outgoing traffic 
through this connection.

Specific LAN ports can be selected on the Interface Group screen (

Enter 802.1P 
Priority

IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a 
MAC-layer frame that contains bits to define class of service. 

Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this 
connection. The greater the number, the higher the priority level.

Enter 802.1Q VLAN 
ID

Type the VLAN ID number (from 1 to 4094) for traffic through this connection.

Enable VLAN on 
LAN side

Select this to have the Device add a VLAN tag to outgoing packets on the LAN 
ports. 

Apply

Click Apply to save your changes.

Back

Click Back to return to the previous screen.