Aastra Telecom Pro 160 User Manual
Monitoring the AastraLink Status LED
41-001190-01 Rel. 1.1, Rev. 00
7-3
Troubleshooting Solutions
Monitoring the AastraLink Status LED
The LED on the front of the AastraLink Pro 160 indicates the current status of the
device. The table below describes the LED variations.
device. The table below describes the LED variations.
LED Color
Meaning
Off
Power is off.
Steady Green
The AastraLink Pro 160 has successfully completed internal hardware
diagnostic tests and is starting up.
diagnostic tests and is starting up.
Alternating Green/Red
The AastraLink Pro 160 is updating its onboard firmware, either because it is
the first time you started up the device, or you just uploaded a new firmware
image.
the first time you started up the device, or you just uploaded a new firmware
image.
Warning: Do not interrupt power during the system update, as system
corruption can result.
corruption can result.
Flashing Green
The AastraLink Pro 160 has successfully booted and is up and running, ready
to process calls.
to process calls.
Alternating Green/Red/Off
The AastraLink Pro 160 is running in recovery mode. This sequence occurs if
the last boot attempt failed.
the last boot attempt failed.
Try rebooting. If the problem persists, use the recovery procedure described in
Flashing Red
The AastraLink Pro 160 is running in a degraded state:
•
Flash speed: Slow
(approximately once per second) indicates that the
AastraLink is running normally but that a full-duplex network connection
could not be negotiated. This may limit the system capacity and/or cause
problems with collisions or integrity of the network connection, leading to
problems such as WebUI time-outs and garbled voice-path. Recommend
connecting the AastraLink to a full-duplex Ethernet device, such as a
router or switch, rather than a half-duplex device such as a hub.
could not be negotiated. This may limit the system capacity and/or cause
problems with collisions or integrity of the network connection, leading to
problems such as WebUI time-outs and garbled voice-path. Recommend
connecting the AastraLink to a full-duplex Ethernet device, such as a
router or switch, rather than a half-duplex device such as a hub.
•
Flash speed: Fast (approximately 5 times per second) indicates a system
error occurred during startup; the AastraLink software was unable to
initialize correctly. Contact Aastra support for assistance with diagnosing
the problem.
error occurred during startup; the AastraLink software was unable to
initialize correctly. Contact Aastra support for assistance with diagnosing
the problem.
Steady Red
Hardware self-test failure; system halted. Try rebooting. If LED remains
steady red, contact Aastra Support.
steady red, contact Aastra Support.
Steady Amber
The Aastralink is in the process of restoring factory default settings.