Aastra Telecom Pro 160 User Manual

41-001190-01 Rel. 1.1, Rev. 00

7-7

Troubleshooting Solutions

After restoring factory default settings on the AastraLink device, you must 
re-register an IP phone with the device, and use it to specify initial startup 
configuration parameters. 

The instructions in this section assume you have previously configured an Administrator IP 

phone on your AastraLink network. Therefore, this section does not describe initial IP phone setup 
or installation instructions. For this type of information, see the AastraLink Administrator’s 
QuickStart Guide. 

2

Verify that the LED on the front of the device is flashing green, or flashing red. 

3

Use the end of a paperclip to press, and then hold the reset switch (about 5 seconds) until the light 
turns amber. Release the reset switch. 

Once the LED turns amber, the AastraLink begins reverting to its factory default settings. The 
process takes up to 30 seconds to complete. During this process, all configuration information, 
voicemail, and other files stored on the AastraLink are erased. 

The AastraLink then begins its normal reboot process. The LED turns steady green as the device 
performs internal hardware diagnostic tests. Once tests are complete, the LED flashes green, 
indicating a successful reboot. The device is now up and running.