Aastra Telecom 41-001343-02 User Manual

41-001343-02 REV04 – 05.2014

Parameter – 
handsfree tx gain

Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg

This is the increased (+db) or decreased (-db) amount of signal transmitted from the base 
microphone to the far-end party. The amount of Tx gain in the IP phone firmware has 
been reduced to avoid side-tone and echo on the local and far-end equipment. This 
parameter allows you to adjust the Tx gain settings to best suit your comfort level and 
deployment environment.

Note:
The example below increases the speakerphone mic transmit gain by 10 db.

Integer

0

-10 db to +10 db

handsfree tx gain: 10

Parameter – 
audio mode

Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg

Allows you to configure how the "handsfree" key on the IP phone operates.

Integer

0

0 Speaker - Calls can be made or received using the handset or handsfree speakerphone 
and can be switched between the two modes by pressing the d /fkey. When on speaker, 
you can return to using the handset by placing the handset on the cradle and picking 
it up again.

1 Headset - Calls can be made or received using the headset. Calls can be switched 
between the headset and handset by pressing the d /fkey.

2 Speaker/headset - Incoming calls are sent to the speakerphone. By pressing the d /fkey, 
you can switch between the handsfree speakerphone, the headset, and the handset.

3 Headset/speaker - Incoming calls are sent to the headset. By pressing the d /fkey, you 
can switch between the headset, the handsfree speakerphone, and the handset.

audio mode: 2

Parameter – 
web interface enabled

Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg

Specifies whether or not to disable the web user interface

Integer

1 (admin/user enabled)

0 (admin/user disabled)
1 (admin/user enabled)
2 (only admin enabled)

web interface enabled: 0