Telular SX5P CDMA2000 User Manual

5

3.  Snap the wedge tabs on the thick end of

the wedge into the top tab slots - see
Figure 14. The wedge will fit snugly, so it
may be necessary to press the thick end
of the wedge towards the bottom tab slots
(if the wedge tabs at the thin end have
been inserted) in order to snap it into the
top tab slots.

4.  Mark two hole locations 83 mm (3-1/4

inches) vertically apart and drill two holes
into the wall.

5.  Install the screws (not supplied) into the

wall, leaving a gap of approximately 3 mm 
(1/8 inches) between the screw head and
the wall.

6.  Align the mounting holes with the screws

and mount the SX5 onto the screws - see Figures 15 and 16.

1  Connect the barrel connector of the power supply to the AC power input on the rear panel of

the SX5 - see Figure 17.

2.  Plug the AC power cord into the power supply.
3.  Turn the AC/Battery switch to the AC position.
4.  Plug the AC power cord into the wall socket. The SX5 will power up automatically.
5.  Check the cellular signal strength and move the unit until the best signal possible is 

achieved - see the Service Indication section of this manual.

AC Power Cord

Wall Socket

Power Supply

AC Power

Input

Barrel

Connector

Figure 16 – Mount the SX5 onto the screws.

83 mm (3-1/4 inches)

Figure 15 – SX5 mounting hooks.

Mounting

Holes

Attach thick end of

wedge at bottom 

of the SX5.

Figure 14 - Wedge attached for wall-mounting.

AC/Battery

Switch

Figure 17 – SX5 AC power connection.