Lg Electronics 20A User Manual
●
aria
20 SERIES DIGITAL KEY TELEPHONE SYSTEM USER GUIDE:
aria
20A,
aria
20,
aria
20W
13
Flash
Button
Procedures
While connected to an outside line, press FLASH button.
Range
May disconnect outside line and re-seize dial tone if programmed . It can be used to send a recall to line, when the system is
connected with a PBX or Enhanced Feature Analogue Line.
Placing a CO Call on Hold
Button
Procedures
While on a CO call
Press HOLD/SAVE button.
- Hold Preference for system hold or exclusive hold is set at Installer programming
To retrieve the call,
Lift handset and press flashing outside line button. OR dial 8 # and the CO line
number
Range
Group Call Pick-up
Button
Procedures
Range
You should be in the same pick-up group as ringing phone.
You hear an unattended phone ringing.
Lift handset or press MON button.
Dial 6 6
Lift handset or press MON button.
Dial 6 6
Conference
Button
Procedures
Range
To establish a conference,
Call desired party. (internal or outside)
Press CONF button. (CONF button is lighting and the called
Press CONF button. (CONF button is lighting and the called
party is put on exclusive hold.)
Call the next party.
Press CONF button twice. (once if adding additional parties)
Conference is established.
Press CONF button twice. (once if adding additional parties)
Conference is established.
To exit a conference (unsupervised),
Press CONF button in the supervisor station and hang up.
Other parties are still connected.
NB:
At most 3 parties
can be active in
a conference.
At most 3 parties
can be active in
a conference.
Re-entering a conference,
Lift handset or press MON button.
Press CONF button.
Press CONF button.
To drop an outside party, (not available in aria 16/20W)
(You should be active in the conference.)
(You should be active in the conference.)
Press outside line of party you wish to drop.
Hang up or press MON button.
Hang up or press MON button.
To terminate the conference,
Hang up or, press CONF button if unsupervised.
On LKD-2N/S, 8D/S,
Conference feature can be accomplished by programming
a flexible key as CONF button (TRANS + 91).
Programming Your Name into Display
Button
Procedures
Press TRANS/PGM button.
Press SPEED button and dial 0 0.
Press SPEED button.
Enter your name. (up to 7 letters using the code in “Storing Dial by name.)
Press HOLD/SAVE button.
Press SPEED button and dial 0 0.
Press SPEED button.
Enter your name. (up to 7 letters using the code in “Storing Dial by name.)
Press HOLD/SAVE button.
Range
You can program your name and people using display phones will see your name instead of your station number.
Available by Software:
16: Above V4.0
20W: Above V3.0)
16: Above V4.0
20W: Above V3.0)
System Features