Lucent Technologies 1079984G3 User Manual
84
Issue 1
April 1997
Recorded Announcements
3.
Press
and record after the tone. Hang up, press
, or press the
switchhook when finished.
4.
Dial the extension number of the announcement you just recorded.
5.
Listen to the recording. If you need to re-record the message, repeat
Steps 1 through 3.
Steps 1 through 3.
6.
If the message is satisfactory, hang up and repeat Steps 1 through 3 to
record the rest of the messages.
record the rest of the messages.
The integrated announcements circuit pack has the following recording time
limit based on the sampling rate used:
limit based on the sampling rate used:
■
8 minutes, 32 seconds at 16 KHz
■
4 minutes, 16 seconds at 32 KHz
■
2 minutes, 8 seconds at 64 KHz.
For the speech synthesizer circuit pack (TN725B), do the following:
1.
At a voice terminal, dial the Verify Wakeup Announcements feature
access code _____.
access code _____.
2.
Dial 1 or 2.
■
Listen to the announcement. There may be a short delay before
you hear the announcement.
you hear the announcement.
3.
If the wakeup announcement is absent, distorted, inaudible, or defective
in any way, follow local procedures to correct the problem.
in any way, follow local procedures to correct the problem.
Administration
0
change feature-access-codes
■
Use this form to add the Announcement and Verify Wakeup Announce-
ment feature access codes.
ment feature access codes.
1
Drop