Mitel IP DECT Stand User Manual
Configure Handset from the Handset Display Menu
Page 14
Mitel
®
5000 CP IP DECT Stand Configuration and Administration Guide – Issue 1.0, May 2010
14.
Using the handset dial pad, enter the settings listed in the following table. To enter
spaces and special characters, press Options and then press Insert symbols.
spaces and special characters, press Options and then press Insert symbols.
15.
Save the information.
16. Press
Back repeatedly until you return to the System Settings menu.
17. Select
Time and Date and press OK.
18. Select
Time Server and press OK.
19.
Using the dial pad, enter the hostname of a time server on the internet, such as
pool.ntp.org
pool.ntp.org
, and press OK.
20. Press
Yes to save.
21. Select
Timezone and press OK.
22.
Select the time difference between Greenwich Mean Time (GMT) and your current
location. For example, if you were located in New York, USA, which observes EST you
would select GMT– 5 hours. Press OK.
location. For example, if you were located in New York, USA, which observes EST you
would select GMT– 5 hours. Press OK.
23. Either,
Press
Back repeatedly until the reset gateway prompt appears, and then press
Yes.
Or, in the System Settings menu, select Reset Gateway, press OK, and then press Yes.
The handset display shows “Unknown SIP Account” and then changes to “Searching for
Gateway”. After approximately 30 seconds, the handset idle display appears. Basic
handset configuration is complete.
Gateway”. After approximately 30 seconds, the handset idle display appears. Basic
handset configuration is complete.
Table 2.
Handset Settings
Menu Item
Setting
Display name
Enter the user name assigned to this handset.
User name
Enter the handset extension number (as
programmed on the 5000 CP). Note that you
need to change the input mode from alphabetical
to numeric using the Option softkey.
programmed on the 5000 CP). Note that you
need to change the input mode from alphabetical
to numeric using the Option softkey.
Account name
Enter the user name assigned to this handset
account.
account.
Password
Enter the Station Password (as programmed on
the 5000 CP). Note that you need to change the
input mode from alphabetical to numeric using
the Option softkey.
the 5000 CP). Note that you need to change the
input mode from alphabetical to numeric using
the Option softkey.
If the Station Password is blank, then the entry in
this field is irrelevant.
this field is irrelevant.
Authentication name
Enter the handset extension number (as
programmed on the 5000 CP)
programmed on the 5000 CP)
Registrar
Enter the IP Address or FQDN of the host 5000
CP.
CP.