Grizzly G0637 User Manual
G0637/G0638 Cyclone Dust Collector
-39-
Do NOT put hands or
small objects near inlet
openings during opera-
tion. Objects sucked
into the inlet will meet
with the impeller blade.
Failure to heed this
warning could result in
property damage or per-
sonal injury.
General
Operating your Model G0637/G0638 is simple
and straightforward. Blast gates located at each
of the machines controls the air flow from the
woodworking machine to the dust collector. If a
machine is not being used, keep the blast gate
closed to maintain higher levels of efficiency
throughout the system.
and straightforward. Blast gates located at each
of the machines controls the air flow from the
woodworking machine to the dust collector. If a
machine is not being used, keep the blast gate
closed to maintain higher levels of efficiency
throughout the system.
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Operation Safety
SECTION 6: OPERATIONS
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
DO NOT use the dust collector for any
other purpose besides collecting dust from
connected woodworking machines. A dust
collector should NEVER be used as a shop
vacuum and IS NOT a substitute for an air
filter system. For safest use, wear a respira-
tor and use an air cleaner in addition to the
dust collector.
Remote Control
The remote control for the Model G0637/G0638
is IR (infrared) rather than RF (radio frequency) to
prevent accidental startups by other common RF
items like garage door openers.
is IR (infrared) rather than RF (radio frequency) to
prevent accidental startups by other common RF
items like garage door openers.
Because this remote system is IR, the remote
control must be pointing directly at the control box
with an unobstructed line-of-sight view.
control must be pointing directly at the control box
with an unobstructed line-of-sight view.
If you place your dust collector in a different room
or outside of your shop, you must mount the switch
in the shop and wire it through the wall to the dust
collector to make use of the remote control.
or outside of your shop, you must mount the switch
in the shop and wire it through the wall to the dust
collector to make use of the remote control.