Panasonic KX-TVS80 User Manual
4.2
CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TA624
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX
69
CAUTION
Setting the DIP switch to position 5 will default the Voice Processing System, resulting in a
loss of all user programming, and voice messages (except User1 and User2 prompts).
loss of all user programming, and voice messages (except User1 and User2 prompts).
10.
Plug in and power up the KX-TVS50/80 and wait approximately 2.5 min while the system
initializes.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2.
done as described in Section 2.
Plug in and turn the power switch to ON on the KX-TA624. The calls to the VPS can be
processed after the Power Indicator stops flashing.
processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
•
The Power Indicator light goes on.
•
The Power Indicator light begins to flash.
•
"Checking Flash Memory Cards." is displayed on the screen.
Screen output:
•
The VPS tests the CPU card, the flash memory, and the ports
until "1...2...3..." is displayed.
until "1...2...3..." is displayed.
•
Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
PORT TEST...
SYSTEM SETUP
1... 2... 3...
SYSTEM SETUP
1... 2... 3...
Checking Flash Memory Cards.
Please wait...
Please wait...
Active COs: 1 2
APT Interface Connection is Established
** ON LINE MODE **
APT Interface Connection is Established
** ON LINE MODE **