Panasonic KX-TVS80 User Manual

70

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX 

This message is shown when the digital (APT) connection between the VPS and 
telephone system cannot be established.

Start up completed.

The Power Indicator light stops blinking when the start-up has been successful. (The 
delay varies according to the system's condition.) 

"**ON LINE MODE**" is displayed.

System prompt [>] is displayed on the screen. To enter system administration, Press 
ENTER. All parameters can be set through the menu-driven program.
 

Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] then 

QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.

The PBX is not a KX-TA624 system. 
Since the default PBX type for the 
KX-TVS50/80 is to KX-TA624 at the 
factory, this message will always 
appear when connecting to another 
type of PBX.

Change the PBX type by using 
Quick Setup (see Section 5).

The cabling between the PBX 
extension ports and the VPS is not 4-
wire or is improperly connected.

Confirm the cabling is 
connected as described in 
Section 2 INSTALLATION.

The PBX is a KX-TA624 but does not 
have the proper level of software 
required to support APT Integration.

Contact National Parts Center 
at 1-800-833-9626
or use Inband Integration under 
hardware settings.

The PBX is not programmed properly 
to support APT Integration.

Do required integration 
programming as described in 
this chapter.