Panasonic KX-TD1232C User Manual
APPENDIX
User Manual
377
6.1.4
Troubleshooting
If a power failure should occur...
Your System enables conversations between specific outside lines and extensions (Power
Failure Transfer), and supports system data backup.
Failure Transfer), and supports system data backup.
Power Failure Transfer
Specific extensions are automatically connected straight to specific outside lines. This provides
outside line conversations between the pre-assigned extensions and outside lines:
outside line conversations between the pre-assigned extensions and outside lines:
<KX-TD816>
Outside line 01 is connected to extension jack number 01.
Outside line 02 is connected to extension jack number 02.
Outside line 05 is connected to extension jack number 09.
Outside line 06 is connected to extension jack number 10.
<KX-TD1232>
Outside line 01 is connected to extension jack number 01.
Outside line 02 is connected to extension jack number 02.
Outside line 03 is connected to extension jack number 09.
Outside line 04 is connected to extension jack number 10.
Outside line 09 is connected to extension jack number 17.
Outside line 10 is connected to extension jack number 18.
•
All other conversations are disconnected during a power failure.
•
Digital proprietary telephones (DPTs) cannot be used during a power failure. SLTs can
work in the event of a power failure.
work in the event of a power failure.
•
When power is restored after a power failure, your system automatically restarts
operation, maintaining as much of the previous system data as possible.
operation, maintaining as much of the previous system data as possible.
Problem
Probable Cause
Possible Solution
Nothing is heard in the hands-
free mode.
free mode.
The "Headset" mode is
selected.
selected.
When the headset is not used, set
the mode to "Handset."
Refer to "Handset/Headset
Selection" in Station
Programming (Section 2), or
"Initial Setting" (Section 1).
the mode to "Handset."
Refer to "Handset/Headset
Selection" in Station
Programming (Section 2), or
"Initial Setting" (Section 1).
The unit does not ring.
•
The outside number is not
programmed.
programmed.
•
The Ringer Volume is set
to "OFF".
to "OFF".
•
For programming outside
numbers, refer to the
Installation Manual.
numbers, refer to the
Installation Manual.
•
Increase the Ringer Volume.
Refer to "Initial Setting"
(Section 1).
Refer to "Initial Setting"
(Section 1).