Panasonic KX-TG2386 User Manual

“No link to base. Move 
closer to base, try 
again.” is displayed and an 
alarm tone sounds.

• You are too far from the base unit. Walk 

closer to the base unit.

• Confirm the base unit’s AC adaptor is 

plugged in.

• Raise the base unit antenna.
• If the above remedies do not solve the 

problem, the handset may have lost 
communication with the base unit. Register 
the handset again (p. 60).

Static, sound cuts in/out, 
fades. Interference from other 
electrical units.

• Move the handset and base unit away from 

other electrical appliances (p. 3).

• Walk closer to the base unit.
• Raise the base unit antenna.
• If the unit is connected to a telephone line 

with DSL service, you may hear noise from 
the receiver or speaker during conversations. 
We recommend connecting a noise filter 
(contact your DSL service provider) to the 
telephone line between the base unit and the 
telephone line jack.

The handset and/or base unit 
does not ring.

• The ringer volume is turned off. Set to high, 

medium, or low (p. 17, 18).

The handset display is blank.

• If the handset display is blank, fully charge 

the battery (p. 10).

You cannot program any 
function items.

• Programming is not possible while the 

handset and/or base unit is being used.

• Do not pause for over 60 seconds while 

programming.

• Walk closer to the base unit.
• While another user is listening to messages 

or the Answering System is handling a call, 
you cannot program. Try again later.

While programming or 
searching, the handset starts 
to ring and the program/
search stops.

• A call is coming in. To answer the call, press 

[C], [s] or [SP-PHONE]. Start again from 
the beginning after hanging up.

PQQX14302ZB.book  77 ページ  ２００４年７月３０日　金曜日　午後４時５２分