Clarity C510 User Manual

The phone unit may be mounted on a
standard wall plate.

The mounting bracket will mount on
the telephone with the wide end of the
bracket towards the bottom of the
phone.

1. Plug one end of the flat telephone 

line cord into the jack marked TEL 
LINE located on the back of the 
telephone.

2. Insert the plug of the AC adapter

into the jack marked 12 VDC 
located on the back of the base unit.

3. Place the mounting bracket on the 

telephone with the wide end of the 
mounting bracket towards the bot-
tom of the phone.With the back of 
the unit facing up insert the sup-
plied mounting bracket’s upper 
tabs into the base’s upper tab 
slots. Depress the tabs located at 
the bottom of the mounting brack-
et and insert the tabs into the 
lower tab slots. Release the tabs 
to lock the mounting bracket into 
place.

4. Pull up on handset knob and turn so 

that the knob extends out.This will 
hold the handset in the place when 
the phone is wall mounted.

5. Plug the flat telephone line cord 

into the wall plate jack, then align 
the mounting bracket’s keyhole 
slots with the wall plate studs and 
slide the base of the phone down-
ward to secure it on the wall.

6. Plug the AC adapter into an 

electrical outlet.

7. Set the TONE/PULSE switch located

on the back of the base to correct 
dialing mode. Please check with 
your local telephone company if 
uncertain of the type of service.

8. Plug one end of the coiled handset 

cord into the bottom of the handset.
Plug the other end of the handset 
into the modular jack marked 
HANDSET located on the left side of
the phone. Place receiver in the 
cradle.

10