Sharp PG-A10S User Manual

▼Keycode input box

• The language preset at the factory is English.

If you want to change the on-screen display to
another language, reset the language accord-
ing to the procedure on page 28.

• The power indicator illuminates red, and

the projector enters standby mode.

• The power indicator illuminates green.

After the lamp replacement indicator illu-
minates and the warming up message
on the display disappears, the projector
is ready to start operation.

Note

• The lamp replacement indicator illu-

minates, indicating the status of the
lamp.

Green: The lamp is ready.
Blinking in green: The lamp is warming

up and shutting down.

• If the power is turned off and immedi-

ately switched on again, the lamp re-
placement indicator may take some
time to illuminate.

• When controlling the projector using

RS-232C commands from a com-
puter, wait for at least 30 seconds af-
ter the power has been turned on, and
then transmit the commands.

• The projector cannot be operated while

the warming up message is displayed.

• When “Anti-Theft” (see page 48) is set,

the keycode input box will appear. Enter
the keycode.

Note

• When entering the keycode, press the

buttons previously set on the projec-
tor or the remote control.

• For details about the Anti-Theft func-

tion, refer to “Anti-Theft (Setting the
Anti-Theft)” on page 48.

▼Keycode input box

▼Warming up message

A10X_A10S#E_Print#p26_31.p65

03.2.4, 2:04 PM

26