Avaya S8400 User Manual
Chapter 8: Installation verification
66
Installing and Configuring the Avaya S8400 Media Server
February 2006
Faceplate interfaces
The TN8400AP Media Server maintenance complex has the following faceplate interfaces as
shown in
shown in
●
- This solid red LED is lit when there is a detected
TN8400AP Media Server circuit pack failure.
- Solid red during a turn on sequence and during a reset. When turn on or reset is
complete and there are no failures, the LED turns off.
- Solid red indicates that there is a failure on the TN8400AP Media Server circuit pack.
●
Communication Manager Processor Complex remains in a shutdown state until power is
removed and then reapplied. This switch gracefully turns off the operating system and file
system so as to not destroy data and require a disk recovery process.
removed and then reapplied. This switch gracefully turns off the operating system and file
system so as to not destroy data and require a disk recovery process.
●
- This green LED provides a visual status of the shutdown
process.
- LED off indicates the system is operational.
- Flashing indicates that the shutdown is in progress.
- Solid indicates It is safe to remove the TN8400AP Media Server circuit pack from the
carrier or turn off the carrier where the TN8400AP Media Server circuit pack resides.
●
- This red LED indicates that a major alarm condition is detected.
●
- This green LED shows the status of the Services
Ethernet link. The LED is on when the link is up. The LED flashes any time data transitions
are detected.
are detected.
●
single 10/100 BaseT Ethernet interface by an RJ-45 connector. This port is connected to
the Services laptop, and is used for on-site Services access to the system.
the Services laptop, and is used for on-site Services access to the system.
●
- This yellow LED indicates that the Compact Flash memory is
being accessed.
●
- This slot provides access for storage of translations and selection
application data.
●
- Used to communicate with peripheral equipment
such as a USB CD/DVD ROM for software/firmware updates. Do not connect the modem
to this port.
to this port.
●
- This green LED:
- The LED is on when the Maintenance Processor detects that the primary application of
the Communication Manager Processor is loaded and running.
- The LED is off during a power-on reset or when the system is shutting down.
- The LED flashes when a diagnostic /self test is running.