Avaya S8400 Manuale Utente

The TN8400AP Media Server maintenance complex has the following faceplate interfaces as 
shown in 

●

 - This solid red LED is lit when there is a detected 

TN8400AP Media Server circuit pack failure.

- Solid red during a turn on sequence and during a reset. When turn on or reset is 

complete and there are no failures, the LED turns off.

- Solid red indicates that there is a failure on the TN8400AP Media Server circuit pack.

●

 - Hold in the shutdown button for 2 seconds to start a shutdown. The 

Communication Manager Processor Complex remains in a shutdown state until power is 
removed and then reapplied. This switch gracefully turns off the operating system and file 
system so as to not destroy data and require a disk recovery process.

●

 - This green LED provides a visual status of the shutdown 

process.

- LED off indicates the system is operational.

- Flashing indicates that the shutdown is in progress.

- Solid indicates It is safe to remove the TN8400AP Media Server circuit pack from the 

carrier or turn off the carrier where the TN8400AP Media Server circuit pack resides.

●

 - This red LED indicates that a major alarm condition is detected.

●

 - This green LED shows the status of the Services 

Ethernet link. The LED is on when the link is up. The LED flashes any time data transitions 
are detected. 

●

 - This Ethernet port provides access to a 

single 10/100 BaseT Ethernet interface by an RJ-45 connector. This port is connected to 
the Services laptop, and is used for on-site Services access to the system.

●

 - This yellow LED indicates that the Compact Flash memory is 

being accessed.

●

 - This slot provides access for storage of translations and selection 

application data.

●

 - Used to communicate with peripheral equipment 

such as a USB CD/DVD ROM for software/firmware updates. Do not connect the modem 
to this port.

●

 - This green LED:

- The LED is on when the Maintenance Processor detects that the primary application of 

the Communication Manager Processor is loaded and running.

- The LED is off during a power-on reset or when the system is shutting down.

- The LED flashes when a diagnostic /self test is running.