Avaya S8100 User Manual
Checklists and job aids
Upgrade an S8100’s R9.5 software by replacing the S8100
S8100 Installation and Upgrades
29
November 2003
20
Wait approximately 5 minutes, then
connect the laptop to the service jack on the
front of the TN2314 Processor board.
connect the laptop to the service jack on the
front of the TN2314 Processor board.
a
Connect a cable from the laptop’s PCMCIA Ethernet
card to an RJ45 coupler.
card to an RJ45 coupler.
b
Connect a cross-over (flip) cable from the coupler to
the RJ45 service jack on the front of the TN2314
Processor board.
the RJ45 service jack on the front of the TN2314
Processor board.
21
LT-IE
– Connect to the TN2314 processor
with Internet Explorer.
Open Internet Explorer on the laptop, type
192.11.13.6
in the
URL address bar, and press Enter.
22
LT-IE
– Open the S8100’s desktop.
Note: Terminal server client and terminal
services Active X must be installed on the
laptop. The easiest way to do this is to
upgrade your Windows 95 laptop’s browser
to Internet Explorer 5.5.
services Active X must be installed on the
laptop. The easiest way to do this is to
upgrade your Windows 95 laptop’s browser
to Internet Explorer 5.5.
a
Click ‘Administer System’ and login using
lucent3
for login and password. A domain is not required.
Select 'continue' at license agreement window.
Select 'continue' at license agreement window.
b
Select ‘Login to <xxx>’ under Remote Control –
Terminal Services (where <xxx> is the host name used
for this system).
Terminal Services (where <xxx> is the host name used
for this system).
c
If a VBScript error message appears, click OK.
d
Click the Connect button (leave the Server field
blank).
blank).
e
If a VBScript message appears, click OK (you can
resize the Terminal Services screen to full size by
pressing ctlr-alt-Pause). A login window will open.
resize the Terminal Services screen to full size by
pressing ctlr-alt-Pause). A login window will open.
f
Login using
lucent3
. After login, the S8100’s
Windows 2000 desktop is displayed.
23
SDT
– On the S8100’s desktop, double-
click the time display and set the time, time
zone, date, and Daylight Savings.
zone, date, and Daylight Savings.
The time display is in the tool tray at the lower right of the
desktop.
desktop.
24
SDT
– Disable modem compression.
a
Click Start
→
Settings
→
Control Panel.
b
Double-click Phone and Modem Options.
c
Click the Modems tab.
d
Select the installed modem and click Properties.
e
Click the Advanced tab.
f
Click Change the Default Preferences.
g
In the Compression drop-down list, select Disabled.
h
Close each dialog by clicking
OK
, and close the
Control Panel window.
25
SDT
– Open a bash shell window.
Click
Start
→
Run
→
bash
.
26
BS
– Verify the software’s version.
Type
swversion
. Ensure that the Release number and
MultiVantage version number are as expected.
Step
Details