Lucent Technologies 6 User Manual

Issue 1

February 1998

System Components 

Page 3-46

Power-Related Hardware 

3

Your Lucent Technologies representative can plan for added power-related 
hardware to provide your system with additional power and protection from power 
surges, although most systems do not need extra surge protection. Other 
accessories apply to system-specific conditions.

*

Release 5.0 and later systems only; in earlier releases, a group can have only one primary 
announcement device.

†

If you use equipment that rebroadcasts music or other copyrighted materials, you may be 
required to obtain a copyright license from and pay license fees to a third party such as 
American Society of Composers, Artists, and Producers (ASCAP) or Broadcast Music 
Incorporated (BMI). Or you can purchase a Magic on Hold system, which does not require 
you to obtain such a license, from Lucent Technologies.

Loudspeaker Paging:
External paging system using DTMF 
signaling. Customer paging systems 
require an interface unit: for 3-wire 
input, PagePal can be used.

Connects to LS or GS/LS trunk jack.

Bidirectional paging supported; only one line jack 
is needed for multizone paging.

Connects to single-line phones.

Can be connected to:

008 OPT, 016 (Release 4.0 and later), or 012 T/R 
extension jack

MFM and MLX extension jack,

GPA and analog extension jack

†

Any FCC-registered 8-ohm music 
source or recorded announcement 
device.

Connects to LS or GS/LS trunk jack.

Music coupler required.

SMDR Printer:
Must be located within 50 ft. (15 m) of 
control unit or use Asynchronous Data 
Unit (ADU); should be 1,200-bpi serial 
printer set at no parity and one stop bit.

Connects to SMDR jack on processor module.