LOEWE Individual 32 Compose 3D User Manual

Page of 158
- 8
english
For your own safety and to prevent unnecessary damage to your device, 
read and comply with the following safety instructions:
Proper use and environmental conditions
This TV set is designed exclusively for reception and reproduction of 
video and audio signals and is designed for living rooms or office facilities, 
and should not be operated in rooms with high humidity, such as a 
bathroom, or sauna, or where there is a high concentration of dust (e.g. 
workshops). The manufacturer‘s warranty is only valid for use in the specified 
permissible environment.
If the set is used outdoors ensure that it is protected against moisture 
(rain, splashing water, or dew). High humidity and dust concentrations 
cause leak currents in the device, which can cause a shock hazard if the 
device is touched, or a fire.
If you have brought the set into a 
warm environment from the cold
then wait for about 1 hour before 
switching it on to avoid formation of 
condensation.
Do not place any objects filled with 
liquids on top of the appliance. Pro-
tect the appliance against dripping 
and splashing water.
Candles or naked flames must be kept 
away from the appliance at all times 
to prevent it from catching fire.
Never place the TV set in a position where it is exposed to vibrations. This 
can lead to material overload.
Transporting
Only transport the device in vertical position. Grasp the device on the 
upper and lower edges of the housing. Sets without system speakers 
should never be placed on the protruding control unit on the bottom of 
the set. This could damage the control unit.
If the set has to be put down during packing/unpacking, place the TV 
set with the entire front surface lying flat on a soft underlay such as a 
blanket or the felt from the packing material. 
The LCD screen is made of glass or plastic and can break if not handled 
properly.
Always wear rubber gloves to carry the TV set if the LCD screen is dam-
aged and liquid crystal might be leaking out. In the case of skin contact 
immediately wash thoroughly with water.
Power supply
The wrong voltage can damage the set.     This equipment must only be 
connected to a mains power supply which has the same voltage and 
frequency as that specified on the rating plate; use the mains cable 
provided. The mains plug of the TV set must be easily accessible so that 
the device can be disconnected from the mains at any time. When you 
unplug the mains plug, do not pull on the cable rather pull on the plug 
housing. The cable in the mains plug could be damaged and cause a 
short circuit the next time it is plugged in.
Lay out the mains cable in such a manner that it cannot be damaged. 
The mains cable must not be kinked or laid over sharp edges, stepped 
on or exposed to chemicals; The latter also applies for the entire equip-
ment. A mains cable with damaged insulation can cause electrical shock 
and is a fire hazard.
Air circulation and high temperatures
The vent slots on the rear panel of the set must always be kept free. 
Please do not place newspapers or cloths on/over the TV. 
Ensure that there is at least 10 
cm free space on the sides and 
above the set for air circulation, 
if the set is placed in a cabinet 
or on a shelf.
  Like any electronic device, your 
TV set requires air for cooling. 
Obstruction of the air circula-
tion can cause fires. 
The set is suitable for different 
installation solutions. See the 
instructions for assembly for the different installation solutions. Stand 
the TV set with the table or floor stand only on a level, sturdy, horizontal 
base. Particularly ensure that the set does not protrude to the front when 
placed in or on pieces of furniture. The TV set may only be operated 
horizontally, the vertical tilt must not be more than 10 degrees maximum. 
The TV set must never be operated on edge, lying on the ground or 
hanging from the ceiling.
Set up the device where it is not exposed to direct 
sunlight and where it 
is not exposed to additional warming through heating elements.  
 Prevent metal items, needles, paper clips, liquids, wax, or similar items, 
from getting into the interior of the device through the vent slots in the 
rear panel. Such objects can cause short circuits in the set, which could 
possibly cause a fire.
If something should get into the interior of the set then immediately 
unplug the mains plug of the device and contact customer service for 
more information.
 For your  safety
10 cm
10 cm
10 cm