Kenwood VC-H1 User Manual

8

The VC-H1 has 10 memory channels to
store captured images.

1 Slide the PWR switch upward to turn

the power ON.

•

The TX/RX indicator lights green.

2 Press [S] to activate both the camera

and LCD monitor.

•

The TX/RX indicator goes out.

3 While looking at the LCD monitor,

turn and focus the camera onto an
object.

4 Press [S] again to capture the image.

•

When capturing is completed, the
camera is deactivated and the TX/RX
indicator lights green again.

5 Press [MR] to store the captured

image in a memory channel.

•

You may skip this step if you do not
store the image.

6 Repeat step 2 to 5 to capture and

store a maximum of 10 desired
images.

• When all channels are full, the

currently selected channel is
overwritten with a newly captured
image.

7 To confirm the stored images, press

[MR].

• The currently selected channel number

appears at the top right of the monitor.

• Each press of [MR] increments the

channel number.

◆

While capturing images, the VC-H1 does not
receive images sent from other parties.

◆

If no operation is performed for approximately
30 seconds with Battery Saver ON {page 11}, the
camera and monitor are deactivated; the default
is ON.

◆

Pressing [S] again immediately after activating
the camera and monitor may cause the captured
image to be distorted; the camera is not yet
ready for image capture.

◆

The VC-H1 does not allow you to specify an
individual image to be erased.  To erase
unnecessary images, use one of the following
methods:
•

Perform Memory Reset to erase all images
at one time  {page 11}.

•

When all channels are full, recall the
unnecessary image, capture a new image,
then press [MR].