Kenwood VC-H1 User Manual

9

When an appropriate SSTV mode and a
desired image is selected, the VC-H1 is
ready to transmit images.

Note:  AF Mute must be switched OFF {page 13} to
transmit an image using Fast FM mode; the default
is ON.

1 Confirm that the VC-H1 has been

correctly connected with the
transceiver {page 5}.

On the transceiver:

2 Turn ON the power to the transceiver.

3 Select the same frequency as the

other party.

On the VC-H1:

4 Slide the PWR switch upward to turn

the power ON.

•

The TX/RX indicator lights green.

5 Press [MR] to recall an image to be

transmitted.

•

The currently selected channel number
appears at the top right of the monitor.

•

Each press of [MR] increments the
channel number.

• You may just look at the LCD monitor

and focus the camera onto an object
instead of recalling an image; you
need not press [S] to capture an
image.

6 Press [TX] to transmit the image.

• You need not press the PTT switch.

• The TX/RX indicator lights red during

transmission.

• A horizontal line appears and slowly

moves downward to show the progress
of transmission.

• To interrupt transmission, press [RX].

◆

While transmitting, do not place the VC-H1 and
the connection cable close to the transceiver
antenna.  The image on the monitor may be
distorted or erased.

◆

The VC-H1 cannot receive images while
transmitting.

◆

If no operation is performed for approximately
30 seconds after transmission, with Battery
Saver ON {page 11}, the monitor is deactivated;
the default is ON.

◆

If you press [RX] after recalling an image,
Battery Saver {page 11} deactivates the monitor.