Microtek 2400 MHz Series User Manual

 

This equipment has been tested and found to comply with the limits of a Class B device, 
pursuant to PART 15 of the FCC Rules.  These limits are designed to provide reasonable 
protection against harmful interference. 
 
This equipment generates, uses and can radiate radio frequency energy, and, if not 
installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no guarantee that interference will not occur in 
a particular installation.  If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following 
measures: 
•  Reorient or relocate the receiving antenna. 

•  Increase the separation between the equipment and receiver. 

•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

•  Consult your dealer or an experienced radio/TV technician for help. 
 
Any changes or modifications not expressly approved by the manufacturer could void the 
user’s authority to operate the equipment.

 

 
 

 

This equipment is approved only for mobile and base station transmitting devices, 
separation distances of (i) 20 centimeters or more for antennas with gains < 6 dBi or (ii) 2 
meters or more for antennas with gains > 6 dBi should be maintained between the 
antenna of this device and nearby persons during operation.  To ensure compliance, 
operation at distances closer than this is not recommended. 

 
 

 

The term “IC:” before the certification/registration number only signifies that the 
Industry Canada technical specifications were met. 
 
Operation is subject to the following two conditions:  (1) this device may not cause 
interference, and (2) this device must accept any interference, including interference that 
may cause undesired operation of the device.  

( i )