Microtek 2400 MHz Series User Manual

MicroTek Electronics, Inc. recommends that all equipment be bench tested before being 

installed onsite.  This test will ensure that all components of your application are 

functioning properly.   

D

ATA 

T

RANSCEIVER 

S

ET

-

UP 

 

1.  Remove each Transceiver from the box and attach its omni-directional dipole antenna. 
2.  If the device in use operates at a different Baud Rate than the factory setting of 4800, the 

radio must be changed to the desired Baud rate using the Software. See Pages 5 and 6 for 
information on changing the radio’s Baud Rate. 

3.  Select the correct mode of operation; either RS-232 or RS-422/485. Factory set to RS-

422/485. 

4.  For RS-422/485, determine whether a 2-wire or 4-wire set-up is required and wire into 

TX +/- at the control panel and RX +/- at the camera (Pan / Tilt / Zoom Camera 
applications). 

5.  Perform a bench test to make sure all PTZ functions can be controlled wirelessly. 
6.  Mount each Transceiver in an area that has clear, wide-open line of sight to the other 

Transceiver. A weatherproof enclosure must be used if mounted outdoors or in a harsh 
environment. If our weatherproof enclosure is used, mount using the double-sided tape. 
There is enough room in our weatherproof housing for the video transmitter/receiver and 
Data transceiver. 

7.  The red LED will light up when power has been connected and applied. One 12 VDC 

power supply is included in the system for each Transceiver. 

 

Trouble Shooting:  If you cannot control the PTZ functions wirelessly or if you are 
having other operational difficulties, please visit the trouble shooting section in this 
operations manual or contact MicroTek toll free at (888) 366-4276 for technical 
assistance. MicroTek’s toll-free technical assistance is available weekdays from 8 am to 5 
pm Pacific Time. 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

- 2 -