Precor CW34871-101 Manual De Usuario

 

3.  Slide the bottom edge of the front shroud into the space between 

the exercise station and the weight stack frame. 

4.  When the plastic hooks on the front shroud line up with the large 

square holes at the top of the weight stack frame, place the hooks 
into the holes. A second set of hooks halfway up the shroud fits into 
holes in the weight tower frame. If necessary, lift the front shroud 
until the hooks drop into their holes in the weight tower frame and 
lower shroud until the hooks are supporting the shroud on the 
frame. 

Note: When attaching screws, take care to avoid cross-threading. 

5.  Attach the bottom edge of the front shroud using: 

Four 

¹⁄₄”- 20 buttonhead screws   

6.  Leave the screws slightly loose until all four of them are attached 

and the front shroud is positioned correctly, and then tighten them 
using the 

⁵₃₂” hex key until snug. 

Note: Two of the four screw locations are inside the sockets at the 
lower corners of the front shroud. The other two are between them 
along the bottom edge of the shroud. 

 

7.  Replace the weight selection pin in the weight stack. 

Note: Do not tighten all fasteners for the bottom covers until all shroud 
parts are in place. 

1.  Locate the two bottom corner covers (one left, one right). Select the 

cover that corresponds to the pulley location. Tilt the cover down 
and slide the tab under the front shroud. Secure the lower corner 
cover using:   

One 

¹⁄₄”- 20 buttonhead screw 

Note: As you attempt to attach the corner cover, you might 
encounter resistance from the pulley cover. Tilting the corner cover 
down and applying pressure will ensure that it is properly 
positioned. 

Tighten screw using a 

⁵₃₂” hex key until snug.