Samsung SCX-6545N Series Manual De Usuario

Loading originals and print media

To load longer sizes of paper, such as Legal-sized paper, you need to 

adjust the paper guides to extend the paper tray.

Adjust the paper length guide to the desired paper length. It is preset 

to Letter or A4 size depending on the country. To load another size, 

hold the lever and move the length guide to the corresponding 

position. 

•

To avoid damaging the machine, use only 

transparencies designed for use in laser printers.

•

Transparencies used in the machine must be able 

to withstand 180 °C, the machine’s fusing 

temperature.

•

Place them on a flat surface after removing them 

from the machine.

•

Do not leave them in the paper tray for long periods 

of time. Dust and dirt may accumulate on them, 

resulting in spotty printing.

•

To avoid smudging caused by fingerprints, handle 

them carefully.

•

To avoid fading, do not expose printed 

transparencies to prolonged sunlight.

•

Ensure that transparencies are not wrinkled, curled, 

or have any torn edges.

•

To avoid damaging the machine, use only labels 

designed for use in laser machines.

- When selecting labels, consider the following fac-

tors:

- Adhesives: The adhesive material should be sta-

ble at your machine’s fusing temperature. Check 

your machine’s specification to view the fusing 

temperature, see page 126.

- Arrangement: Only use labels with no exposed 

backing between them. Labels can peel off sheets 

that have spaces between the labels, causing 

serious jams.

- Curl: Prior to printing, labels must lie flat with no 

more than 13 mm of curl in any direction.

- Condition: Do not use labels with wrinkles, bub-

bles, or other indications of separation.

•

Make sure that there is no exposed adhesive 

material between labels. Exposed areas can cause 

labels to peel off during printing, which can cause 

paper jams. Exposed adhesive can also cause 

damage to machine components.

•

Do not run a sheet of labels through the machine 

more than once. The adhesive backing is designed 

for only a single pass through the machine.

•

Do not use labels that are separating from the 

backing sheet or are wrinkled, bubbled, or otherwise 

damaged.

•

Do not print on media smaller than 98 mm wide or 

356 mm long.

•

In the software application, set margins at least 

6.4 mm away from the edges of the material.

•

Letterhead must be printed with heat-resistant ink 

that will not melt, vaporize, or release hazardous 

emissions when subjected to the printer’s fusing 

temperature for 0.1 second. Check your machine’s 

specification to view the fusing temperature, see 

page 126.

•

Letterhead ink must be non-flammable and should 

not adversely affect printer rollers.

•

Forms and letterhead should be sealed in a 

moisture-proof wrapping to prevent changes during 

storage.

•

Before you load preprinted paper, such as forms 

and letterhead, verify that the ink on the paper is 

dry. During the fusing process, wet ink can come off 

preprinted paper, reducing print quality.

If you have installed an optional high capacity feeder, refer to Quick 

Install Sheet to adjust paper size.