Toshiba RD-XV48KE Manual De Usuario

25

EN

This unit receives time signals from the channels, and 
sets the clock automatically. Set the channel tuning 
before setting Auto Clock. 

In stop mode, press [SETUP]. Select 
“General Setting” using [

Select “Clock” using [

U \ D], then 

Select “Auto Clock Setting” using 
[

U \ D], then press [ENTER].

Select “ON” using [

U \ D], then 

Press [SETUP] to exit.

B ON\STANDBY] to turn the 

• The Auto clock function is activated.
• This unit will search for the time every time 

when the power is turned off.

• Leave the unit off for about 10 seconds to give it 

time to set the clock.

• If you want to cancel “Auto Clock Setting”, select 

“OFF” using [

U \ D], and then press [ENTER] at 

• The default setting of “Auto Clock Setting” is “ON”.
• The clock may set itself automatically after you 

connect the antenna cable to the unit and plug in the 
mains cable. In this case, the current time will 
appear on the front panel display.

• To set the clock automatically, the channel assigned 

to “P01” must receive the PDC signal.

• The clock cannot be set automatically if you are not 

receiving a channel in your area that carries a time 
signal. In this case, set the clock manually.

• Once the auto clock setting is performed, the unit 

will correct the current time by receiving PDC 
broadcasts whenever the unit is in standby mode.

• The unit will correct the current time automatically at 

8:00 and 1:10, if the unit is in standby mode.

• Between 23:00 and 1:00, the Auto Clock function 

will not operate even when the unit is in standby 
mode.

In stop mode, press [SETUP]. Select 
“General Setting” using [

Select “Clock” using [

U \ D], then 

Select “Clock Setting” using 
[

U \ D], then press [ENTER].

Default date will appear.

Press [ENTER] again.

Press [

P] to move the cursor to the next field. If 

you want to go back to the previous field, press 
[

U \ D], then press [ENTER].

The clock will start.
• Although seconds are not displayed, they will be 

counted from zero.

Press [SETUP] to exit.

• Your clock setting will be lost if either there is a 

power failure or the unit is unplugged for more than 
30 seconds.

E3LG0ED_EN.book  Page 25  Wednesday, April 30, 2008  11:52 AM