GE NX-7002 Manual De Usuario

ROGRAMMING THE LOCATIONS

LOCATION 0

MODULE MODE OF OPERATION FEATURE SELECTION (8 segments)

This location contains the system characteristics.

Segment 1

1 = Enable site initiated downloading (*98 from a keypad)

Enable remote initiated downloading

This setting enables the PC to dial into the NX-7002. It is dependent on

other settings (segment 3, 5 and 6).

Remote initiated download must be from known source
If enabled, program the phone number of the PC in location 168.

Enable remote download at test time
This setting configures the NX-7002 to automatically dial the PC to

initiate an upload/download session after an autotest. You must

program the autotest in the control panel.

Enable auto-answer incoming CSD GSM download call.

If enabled, the NX-7002 will automatically accept an incoming call.
If disabled, the user needs to accept an incoming call (*99) as soon as a

“ding-dong” is heard on the keypad.

Callback required for incoming CSD GSM download call
If enabled, the NX-7002 will call back to the PC before starting an

up/download session.

Use V.110 for site-initiated CSD GSM calls
Enable this setting if the PC is on an ISDN line and is using an ISDN

modem.

Use non-transparent mode for site initiated CSD GSM calls
If you are experiencing problems with upload/download, change this

setting from transparent mode to non-transparent mode or vice versa.

Segment 2

1 = Use SIA DCS as backup format (Contact ID if off)

This setting selects the reporting format when using another device as

backup. The same format must be set on the backup device.

2-8

Reserved

Segment 3

1 = Reserved

Polling enable for TCP/IP (for UL AA)

If polling is enabled, set the polling period in location 162, segment 6.

3-8

Reserved

Segment 4

1-3 Reserved

4 = TCP/IP reporting in SIA (Contact ID if Off)

5-8

Reserved

Segment 5-8

Reserved

NX-7002 Installation manual

Page 13

09/02/05