GE NX-7002 Manual De Usuario

 

       

 

 

The NX-7002 contains up to six report controls. Each report control can be defined for SMS 

reporting, TCP/IP reporting or email reporting (not yet available). This location contains the 

report destination for report control 1. Select from the table below. 

0 

Disabled 

Report control 1 is disabled 

1 

TCP/IP 1 

Reporting to TCP/IP receiver 1 

2 

TCP/IP 2 

Reporting to TCP/IP receiver 2 

3 

Email 1 

Email Reporting to Email Account 1 (not yet 

available) 

4 

Email 2 

Email Reporting to Email Account 2 (not yet 

available) 

5 

SMS 1 

SMS Reporting to Mobile Phone 1 

6 

SMS 2 

SMS Reporting to Mobile Phone 2 

If the primary destination selection (location 1) fails, a backup destination can be selected. If 

using another device as the backup destination, for example, panel dialler, set the reporting 

format (SIA or CID) in location 0, segment 2, option 1 and enable test report events for the 

backup device. This location contains the backup report destination for report control 1. Select 

from the table below. 

0 

Disabled 

Backup Report control 1 is disabled 

1 

TCP/IP 1 

Backup Reporting to TCP/IP receiver 1 

2 

TCP/IP 2 

Backup Reporting to TCP/IP receiver 2 

3 

Email 1 

Backup Email Reporting to Email Account 1 (not yet 

available) 

4 

Email 2 

Backup Email Reporting to Email Account 2 (not yet 

available) 

5 

SMS 1 

Backup SMS Reporting to Mobile Phone 1 

6 

SMS 2 

Backup SMS Reporting to Mobile Phone 2 

255 

Other dialler 

The NX-7002 is not used as backup. Instead another 

dialler is used (for example: panel dialler) 

The delay in seconds before the NX-7002 GPRS module reports. If any other events occur 

during this delay, they are sent with the first event in one message if using SMS reporting. This 

does not apply if using TCP/IP reporting (it does not support multiple events in one message). 

This can be from 0 to 255 seconds. 

NX-7002 Installation manual 

Page 14 

 

09/02/05