Polycom E340 Manual De Usuario
SpectraLink Corporation
Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-J.doc
Page 10
handset will follow the protocol command provided by the PBX if the user selects
PBX
cadence described in section 3.2 User-defined Preferences.
Audio features
Speaker-phone features are not available on the handset unless using the NetLink
Docking Station.
Speaker-phone features are not available on the handset unless using the NetLink
Docking Station.
Line indicators
The Line Indicator bullets on the handset will convert to a solid or flashing number
to mimic the Line LEDs on the deskset, based on the assignment made at the PBX.
The Line Indicator bullets on the handset will convert to a solid or flashing number
to mimic the Line LEDs on the deskset, based on the assignment made at the PBX.
2.6 Startup Sequence
The handset goes through an initialization sequence at startup. The line icons
1
through
9
display and count down as the handset steps through this sequence. This
is usually very rapid. If there is any difficulty at any step that prevents initialization
from continuing, an error message will display and the related icon(s) will stay on.
Please see the Handset Status Messages table at the back of this document for
instructions on how to handle error messages that occur during initialization.
from continuing, an error message will display and the related icon(s) will stay on.
Please see the Handset Status Messages table at the back of this document for
instructions on how to handle error messages that occur during initialization.
Icon
The icon(s) shown in bold turns off when:
123456789 The handset has located and authenticated and associated with at least one AP, and is proceeding to
bring up higher-layer networking functions.
12345678
The handset is either configured for Static IP, or if configured for DHCP the DHCP discovery process
has started.
1234567
If DHCP is configured, a DHCP response was received which contains a good DNS server
configuration.
123456
Note: Only valid on non-SRP protocol. Indicates one of the following:
Static IP configuration, or
SVP Server address found in DHCP response, or
SVP Server address found via DNS lookup.
12345
All networking functions are complete (notably, DHCP) and the handset is proceeding with
establishing the SRP link to the NetLink Telephony Gateway.
1234
The SRP link is established, all network stack initialization is complete, proceeding with application-
specific initialization.
123
The link between the handset and the NetLink Telephony Gateway is established.
(no icons)
EXT. XXX
Initialization is complete. The handset is in standby mode ready to receive and place calls.