Panasonic 700 Guía Del Usuario

DBS-2.3/9.2-700

DBS Manual - Revised April 2000

  Page I-13

     #99xxxx (where xxxx = the site's private password)

5.  After the DBS responds, type P and then press Enter.

6.  Follow the directions on the screen to access the desired program. (See 

“Terminal Programming Commands.”)

Note: The DBS must be equipped with an MFR card and an RAI card to 
allow terminal programming using this method.

When programming through a DISA trunk, perform the following steps:

1.  Dial into the DBS through a DISA trunk.

2.  Once you are connected, type #6 followed by the private password from 

your terminal communications program.

3.  After the DBS responds with REMT>, type P and then press Enter.

4.  Follow the directions on the screen to access the desired program. (See 

“Terminal Programming Commands.”)

Note: The DBS must be equipped with an MFR card and an RAI card to 
allow terminal programming using this method.

SPECIAL NOTICE: If you use the following method, the private password 
must be given to the attendant. Use the new RAI access method instead. (See 
“Additional RAI Access Method”)

When programming through a normal trunk, perform the following steps:

1.  Dial into the DBS through a normal trunk.

2.  Ask the operator to place you on hold and dial #6 followed by the private 

password to transfer you into remote programming.

3.  After the DBS responds with REMT>, type P and then press Enter.

4.  Follow the directions on the screen to access the desired program. (See 

“Terminal Programming Commands.”)