Panasonic 700 Guida Utente
DBS-2.3/9.2-700
DBS Manual - Revised April 2000
Page I-13
#99xxxx (where xxxx = the site's private password)
5. After the DBS responds, type P and then press Enter.
6. Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
Terminal Programming Through DISA
Note: The DBS must be equipped with an MFR card and an RAI card to
allow terminal programming using this method.
allow terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
1. Dial into the DBS through a DISA trunk.
2. Once you are connected, type #6 followed by the private password from
your terminal communications program.
3. After the DBS responds with REMT>, type P and then press Enter.
4. Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
Terminal Programming Through a CO Trunk and Operator Transfer
Note: The DBS must be equipped with an MFR card and an RAI card to
allow terminal programming using this method.
allow terminal programming using this method.
SPECIAL NOTICE: If you use the following method, the private password
must be given to the attendant. Use the new RAI access method instead. (See
“Additional RAI Access Method”)
must be given to the attendant. Use the new RAI access method instead. (See
“Additional RAI Access Method”)
When programming through a normal trunk, perform the following steps:
1. Dial into the DBS through a normal trunk.
2. Ask the operator to place you on hold and dial #6 followed by the private
password to transfer you into remote programming.
3. After the DBS responds with REMT>, type P and then press Enter.
4. Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)