Alesis Legacy Series Audio Processor Synthesizer Manual De Usuario

 

When using the GRIP on 
program material – such as 

a CD or LP - you should 
set the XOVER knob to a 

low setting so that the unit 
doesn’t process the vocals 

or other lead instruments. 
For your reference, the 

graphs at the right provide 
examples of  typical 

frequency response curves 
for bass, kick drums and 

vocals. 
 

This button toggles a high-
pass filter on the main 

outputs. When you engage 
the button, frequencies 

falling below the setting of  
the XOVER knob are 

removed from the main 
outputs (but are still 

present in the XOVER 
output). This allows you to 

separately route the sub-
bass present in the GRIP’s 

signal. 
 

When the XOVER button is not engaged, the main outputs 
carry the GRIP’s total output signal, limited only by the LO 

CUT knob. 
 

This controls output level of  the GRIP’s sub-harmonic 
synthesizer. This signal consists of  the bass frequencies 

produced by the GRIP that were not present in the original 
signal. 

 

This knob controls the action of  a pair of  multi-band 

limiters acting on the Bass and Sub-Bass signals.  You 
should treat it as a tone control. Turning the knob clockwise 

gives you a rounder sound with longer sustain, and turning 
it counterclockwise gives you a faster, more dynamic sound.