Alesis Legacy Series Audio Processor Synthesizer Manual De Usuario

The red LED meter displays the amount of  gain reduction 
applied by the bass limiters. An increase in gain reduction – 

by turning the BASS DRIVE Knob clockwise - will cause 
the meter to light from right to left. 

This knob adjusts the level of  the frequencies that fall 
below the crossover point set by the XOVER knob, except 

for the sub-bass.  
 

This meter indicates the level of  the GRIP’s main output 
signal. As you increase the level by turning the BASS 

LEVEL knob clockwise, this meter lights amber from left 
to right. 

 

  

 

This adjusts the cutoff  frequency of  a steep (6-pole) high-

pass filter, effectively limiting the lowest frequencies that the 
GRIP can output. The unit will output only those 

frequencies that are higher than the one set with the LO 
CUT knob. This knob is useful for protecting your speakers 

from ultra-low frequencies that may cause damage. 
 

This knob controls the level of  the GRIP’s total output 
signal from both the bass and sub-bass channels. 

 

When you activate this button, the audio signal bypasses the 

Grip without being processed. This is useful when you want 
to compare the processed signal with the unprocessed signal. 

This button lights red when you enter BYPASS mode.