Hitachi JU-1000 Manual De Usuario
- 16 -
Gateway PC Software Installation
1. In order for the gateway PC to configure and control the RU-3400JY-S11 connected to the
JU-1000, it is necessary to install the HITACHI provided software.
USB Cable
Gateway PC
IP Control application software installation
IP Control application software installation
Junction Unit
JU-1000
2. Driver installation on PC
a. Connect the JU-1000 to the PC via USB cable. It is not necessary to connect the
RU-3400JY-S11 at this time.
b. Insert the CD-
ROM disc labeled “QUATECH Communication Product Drivers and
Manuals” in the PC’s CD/DVD drive. Follow the instructions on the PC for the
installation of the drivers.
installation of the drivers.
c. When the installation is completed remove the CD-ROM disc in step b above from the
PC’s optical drive.
d. Verify the drivers have been properly installed by: "My compute
r" →"Property"
→"Hardware" →"Device manager" select and expand the "Port (COM & LPT)”, the
eight (8) new USB ports for the JU-1000 should exist as shown below.
eight (8) new USB ports for the JU-1000 should exist as shown below.
e. When connecting and disconnecting the JU-
1000 from the PC’s USB port, ALWAYS
verify that these com ports are open and available for use.
(Please document the COM PORT NUMBERS shown in the window below since
they are needed for TCP/IP address assignment in later steps.)
they are needed for TCP/IP address assignment in later steps.)
COM Port x8
Addition
Addition