Galil DMC-3425 Manual De Usuario

J5

100 pin high
density connector

Banks 0 and 1
provide high
power output
capability.

Banks 2-7 are
standard banks.

Screw Terminals

High Current
Buffer chips (16)

IOM-1964

REV A

GALIL MOTION CONTROL

MADE IN USA

FOR INPUTS:

UX3
UX4

RPX4

FOR OUTPUTS:

UX1
UX2

RPX2
RPX3

 

 

The IOM-1964 is an input/output module that connects to the DB-14064 extended I/O daughter board 
cards from Galil, providing optically isolated buffers for the extended inputs and outputs of the 
controller.  The IOM-1964 also provides 16 high power outputs capable of 500mA of current per 
output point.  The IOM-1964 splits the 64 I/O points into eight banks of eight I/O points each, 
corresponding to the eight banks of extended I/O on the controller.  Each bank is individually 
configured as an input or output bank by inserting the appropriate integrated circuits and resistor packs.  
The hardware configuration of the IOM-1964 must match the software configuration of the controller 
card. 

 

All E-Series controllers have general purpose I/O connections.  On a DMC-3425 and 3415 the standard 
uncommitted I/O consists of: three TTL digital inputs, three TTL digital outputs, and two analog 
inputs. 

 

The DMC-34x5 with the DB-14064, however, has an additional 64 digital input/output points than the 
6 described above for a total of 70 input/output points.  The 64 I/O points on the DB-14064 are 
attached via two 50-pin ribbon cable header connectors.  A CB-50-80 adapter card is used to connect 
the two 50-pin ribbon cables to an 80-pin high-density connector identical to the main axes connector. 
An 80-pin shielded cable connects from the 80-pin connector of the CB-50-80 board to the 80-pin high 
density connector J5 on the IOM-1964.